EarthQuake E43 - Manuale (Pagina 6)

Page 6
ASSEMBLY INSTRUCTIONS ANd PARTS ExPLOSIONS
E43 Model
GetEarthquake.com
800-345-6007
FILLING GAS TANk
1. Shut-off engine and allow engine to completely cool before refill-
ing the gas tank.
2. Move to a well ventilated area, outdoors, away from flames and
sparks.
3. Clean debris from area around the gas cap.
4. Loosen gas cap slowly. Place the cap on a clean, dry surface.
5. Carefully add fuel without spilling.
6. Do not fill gas tank completely full, allow space for fuel to ex-
pand.
7. Immediately replace gas cap and tighten. Wipe off spilled fuel
and allow to dry before starting engine.
NORMAL OPERATION
1. The clutch will transfer maximum power after about two hours
of normal operation. During this break-in period clutch slippage
may occur. The clutch should be kept free of oil or other mois-
ture for efficient operation.
2. Drill holes without placing excessive body weight on the unit.
The auger operates most efficiently with a shaving action
caused by the weight of the unit itself.
3. Never run engine indoors. Exhaust fumes are deadly.
4. Do not use an earth auger in the ice.
5. To attach auger to powerhead, align hole at top of auger shaft
with the output shaft hole. Insert 3/8-16 x 1-1/2” bolt and secure
bolt with provided 3/8” bi-way lock nut using a wrench.
USING ThE SCREW TYPE, MANUAL vENTING GAS CAP
Your powerhead is equipped with a screw type, manual venting gas
cap.
1. Before starting the engine, turn the screw in the top of the gas cap
2-3 turns (counterclockwise) to its venting position. dO NOT turn
the screw to the point that it stops (4-5 turns counterclockwise).
To ensure that gas will not spill during use, check that the gas
cap is screwed on tightly and the gas cap screw is in the venting
position.
2. After using the power earth auger and before putting away or
transporting it in a truck bed, screw the gas cap screw and gas
cap on (clockwise) tightly. This will prevent gas from leaking during
storage. The gas cap will not leak during storage if gas cap is tight
and the screw at the top is tight.
CAUTION
ALWAYS hANdLE FUEL IN A WELL vENTILATEd AREA,
OUTdOORS, AWAY FROM FLAMES OR SPARkS.
dO NOT START ENGINE IF FUEL IS SPILLEd. WIPE OFF
ExCESS FUEL ANd ALLOW TO dRY. REMOvE ENGINE
FROM AREA TO AvOId SPARkS.