4i uk – FBT MCA LTU Manuale d'uso
Pagina 5
4
I
UK
° Prima di utilizzare l’apparecchiatura
assicurarsi che la tensione applicata sia
corretta. Connettere l’amplificatore soltanto su
prese di corrente con riferimento a massa.
° Per evitare rischi di scossa elettrica non
toccare mai fili scoperti connessi ai morsetti
dell’amplificatore quando questo è in funzione.
° L’apparecchio deve essere alimentato dalla
tensione di rete solo dopo aver terminato tutti i
collegamenti.
°
1)
- L’impedenza equivalente degli altoparlanti
connessi deve essere uguale o superiore a
quella indicata sui morsetti
di uscita
dell’amplificatore
2)
- Ogni altoparlante deve essere provvisto di
trasformatore di linea con una tensione di
ingresso uguale a quella di linea (25,70,100V)
° La somma delle potenze degli altoparlanti
non deve eccedere la potenza di uscita
dell’amplificatore
LINEE A BASSAIMPEDENZA
LINEE A TENSIONE COSTANTE
LE LINEE DI ALIMENTAZIONE DEGLI
ALTOPARLANTI DEBBONO ESSERE
REALIZZATE CON CAVI INGUAINATI.
° Before using the amplifier make sure that the
appliance’s voltage is in accordance to your
mains supply. Connect the amplifier only to
grounded mains outlets.
° To avoid the risk of electrical shock never
touch the bare conductors leading to the output
terminals of the amplifier when it is in operation.
° The unit must only be supplied from the
mains after all connections have been
completed.
°
1)
- The total impedance of the speakers
connected must correspond to that selected on
the amplifier’s output terminals
2)
- Each speaker must be equipped with a line
transformer with an input voltage equal to that
of the line (25,70,100V)
°The sum of the power capacities of the
speakers must not exceed the output power
capacity of the amplifier
LOW IMPEDANCE LINES
CONSTANT VOLTAGE LINES
TO CONNECT
LOUDSPEAKERS USE
BOOT’S CABLES EXCLUSIVELY
COLLEGAMENTI
CONNECTIONS
!
!