Pioneer VSX-915-K - Manuale (Pagina 72)

Additional information 13
72
En
No sound is output or a noise
is output when software with
DTS is played back. • Set the digital volume level of the player to full, or to the neutral
position.
• Make sure the player's settings are correct and/or the DTS signal out
is on. Refer to the instruction manual supplied with the DVD player.
• Set the input signal type to
DIGITAL (see Choosing the input signal
on page 37)
When a search is performed
by a DTS compatible CD
player during playback, noise
is output. • This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Everything seems to be set up
correctly, but the playback
sound is odd. • Check that the positive/negative speaker terminals on the receiver
are matched with the corresponding terminals on the speakers (see
Connecting the speakers on page 23).
There seems to be a time lag
between the speakers and the
output of the subwoofer. • See Automatically setting up for surround sound (MCACC) on page 12
to set up your system again using MCACC (this will automatically
compensate for a delay in the subwoofer output).
After using the Auto MCACC
Setup, the speaker size
setting (
LARGE or SMALL ) is
incorrect.
• Low-frequency noise could have been caused by an air conditioner or
motor. Switch off all appliances in the room and rerun the Auto
MCACC Setup.
Can’t operate the remote
control. • Replace the batteries (refer to page 7).
• Operate within 7 m, 30° of the remote sensor on the front panel (refer
to page 32).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• Unplug anything connected to the
CONTROL IN jack and use remote
normally (see Operating other Pioneer components on page 25).
The SR cable is connected,
but the connected
components can’t be
operated with the remote. • Reinsert the SR cable, making sure it’s connected to the right jack
(see
Operating other Pioneer components on page 25).
• Make sure an analog connection has been made between the units.
• This feature only works with Pioneer products.
The display is dark or off. • Press FL DIMMER on the remote control repeatedly to return to the
default.
Problem Remedy
VSX_915.book.fm 72 ページ ２００５年２月１日 火曜日 午前１１時６分