Audio Analogue SRL Audio Analogue SRL - Manuale (Pagina 14)

Power led off
No sound
Power cord incorrectly inserted and/or amplifier switched off
Check that cord is inserted both in the integrated amplifier and in the mains wall socket
and that the switch is in the 'ON' position
Fuse burnt out
Check the fuse in the fuse holder (unplug cord from mains first!!) next to the IEC socket
and eventually replace with same type
Power led glows red
No sound
Volume knob turned completely anticlockwise (standby on)
Turn volume knob up
Power led flashing red an no sound
Speaker protection circuit active
Check for shortcircuit on speakers connections. If the problem still exists, consult an
Audio Analogue technician or dealer
Power led green and no sound
Source not correctly selected
Choose the correct position on the selector
Speaker cables not correctly connected or faulty
Check and connect speaker cables properly
Source not connected or faulty signal cables
Check and connect signal cables
If the suggestions do not work, or your problem isn't in the list, please contact
your Audio Analogue dealer
TROUBLESHOOTING
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
SYMPTOM
CAUSE
REMEDY
CAUSE
REMEDY
CAUSE
REMEDY
15