RCF HL 35-S Flyable 15" Passive Subwoofer - Manuale (Pagina 8)

8
EN
4. RIGGING THE SYSTEM
RCF has developed a complete procedure to set up and hang a line array system starting from software data, enclosures, rigging, accessories,
cables, until the final installation�
WARNING! CAUTION! GENERAL RIGGING WARNINGS AND SAFETY PRECAUTIONS:
- Suspending loads should be done with extreme caution
- When deploying a system always wear protective helmets and footwear
- Never allow people to pass under the system during the installation process
- Never leave the system unattended during the installation process
- Never install the system over areas of public access
- Never attach other loads to the array system
- Never climb the system during or after the installation
- Never expose the system to extra loads created from the wind or snow
WARNING! CAUTION!
The system must be rigged in accordance with the laws and regulations of the Country where the system is used�
It is responsibility of the owner or rigger to make sure the system is properly rigged in accordance with Country and local
laws and regulations�
Always check that all the parts of the rigging system that are not provided from RCF are:
- Appropriate for the application
- Approved, certified and marked
- Properly rated
- In perfect condition
- Each cabinet support the full load of the part of the system below� It is very important that each single cabinet of the
system is properly checked