Bompani BOCBxxx - Manuale (Pagina 21)

967 21
Troubleshooting
TROUBLESHOOTING
- Is the appliance installed near to a heat source?
- Is the temperature setting correct?.
- Is the condenser clean?
3) THE TEMPERATURE INSIDE THE FRIDGE COMPARTMENT
IS TOO LOW
.
- Is the thermostat in the right position?
4) THE APPLIANCE IS VERY NOISY.
- Is the appliance in contact with other furniture or objects?
- Are the pipes on the back touching or vibrating?
- Is the appliance level?
5)5) THE INTERNAL LIGHT DOES NOT WORK
- Contact
the ASSISTANCE SERVICE
6) WATER IS FOUND ON THE FLOOR.
- Is tray V placed correctly and contacting the compressor
surface?
- Is discharge pipe R placed correctly inside the tray?
7) ANOMALIES
In the event of probe malfunction, the three green indicators
start fl ashing simultaneously and sequentially “S2-S3-S4” (fi g.
7). The appliance will keep working with pre-set fi xed cycles;
however, the failed probe must be replaced by an authorised
assistance service as soon as possible.
ELECTRICAL CONNECTION
Check that the mains voltage complies with that indicated on the
rating plate located on the bottom left of the freezer compart-
ment. If the mains socket does not have an earth connection or
if the plug is not suitable for the mains supply system, refer to
a qualifi ed electrician. Do not use adapters or extension leads,
as these may overheat and burn.
WARNING: THIS APPLIANCE MUST BE EARTHED
If the appliance has been fi tted with a non-rewirable plug of
the incorrect type for the mains socket, cut off the plug and fi t
a new one. The removed plug must be thrown away. Inserting
an unsuitable plug into a 13 Amp socket is likely to cause an
electrical hazard. When a non rewirable plug or rewirable 13
Amp (BS1363) plug is used, it must be fi tted with a 15 Amp
ASTA approved (BS1362) fuse. If any other type of plug is used
it must be wired as follows. Connect the GREEN & YELLOW
wire to the earth terminal marked with the letter “E” or earth
symbol, or coloured green or green & yellow. Connect the
BLUE wire to the neutral terminal marked with the letter “N” or
coloured black. Connect the BROWN coloured wire to the live
terminal marked with the letter “L” or coloured red.
TECHNICAL ASSISTANCE SERVICE
Before contacting the Assistance Service:
- Check whether it is possible to rectify the problem by refer-
ring to the “Troubleshooting” guide.
- Restart the appliance to check whether the problem has been
resolved. If the problem still exists, disconnect the appliance from
the mains electricity supply and repeat the operation after one hour.
If the appliance is not working properly or not working at all,
before calling the Technical Assistance Service check that:
- The plug is inserted properly in the mains socket.
- The mains supply is working.
- The temperature is set correctly.
- The doors close properly.
- The power supply voltage corresponds to that of the appli-
ance (± 6%).
- If the problem still exists, call the Assistance Service.
INFORM THE ASSISTANCE SERVICE OF:
- The type of malfunction
- The appliance model
- The serial number
Green and
Yellow to Earth
Blue to
Neutral
13 amp Fuse
Brown
to Live
Cord Clamp
GB