Blomberg WNF 8543 ACE20 - Manuale (Pagina 4)

4 - EN
washing process and wear out.
2. Tighten all hose nuts by hand. Never use a
wrench when tightening the nuts.
3. Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damages caused by them, keep the taps
closed when the machine is not in use.
Connecting to the drain
• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
A Your house will be flooded if the hose comes
out of its housing during water discharge.
Moreover, there is risk of scalding due to
high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of
the discharge hose tightly so that it cannot
come out.
• The hose should be attached to a height of
at least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying it
on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difficult and the
laundry may come out excessively wet.
Therefore, follow the heights described in the
figure.
• To prevent flowing of dirty water back into
the machine and to allow for easy discharge,
do not immerse the hose end into the dirty
water or drive it in the drain more than 15
cm. If it is too long, cut it short.
• The end of the hose should not be bent,
it should not be stepped on and the hose
must not be pinched between the drain and
the machine.
• If the length of the hose is too short, use it
by adding an original extension hose. Length
of the hose may not be longer than 3.2 m.
To avoid water leak failures, the connection
between the extension hose and the drain
hose of the product must be fitted well with
an appropriate clamp as not to come off and
leak.
Adjusting the feet
A In order to ensure that the product operates
more silent and vibration-free, it must stand
level and balanced on its feet. Balance the
machine by adjusting the feet. Otherwise,
the product may move from its place and
cause crushing and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level
and balanced.
3. Tighten all lock nuts again by hand.
A Do not use any tools to loosen the lock nuts.
Otherwise, they will get damaged.
Electrical connection
Connect the product to a grounded outlet
protected by a fuse complying with the values in
the "Technical specifications" table. Our company
shall not be liable for any damages that will arise
when the product is used without grounding in
accordance with the local regulations.
• Connection must comply with national
regulations.
• Power cable plug must be within easy reach
after installation.
• The voltage and allowed fuse or breaker
protection are specified in the “Technical
specifications” section. If the current value of