Instruction for use, I n si de cle a ni ng, O u ts i de clea n in g – Blomberg FRM 1920 A+ Manuale d'uso

Pagina 11: Replacing the interior light bulb

Advertising
background image



I n si de cle a ni ng

Before starting the cleaning, unplug the
appliance from the mains.

It is advisable to clean the appliance when

you defrost it.

Wash the inside with lukewarm water

where you add some neutral detergent. Do
not use soap, detergent, gasoline or acetone
which can leave a strong odour.

Wipe with a wet sponge and dry with a soft

cloth.
During this operation, avoid the excess of
water, in order to prevent its entrance into the
thermal insulation of the appliance, which
would cause unpleasant odours.
Do not forget to clean also the door gasket
especially the bellow ribs, by means of a
clean cloth.

O u ts i de clea n in g

Clean the outside of the freezer by means

of a sponge soaked in soapy warm water,
wipe with a soft cloth and dry.

The cleaning of the outside part of the

refrigerating circuit (motorcompressor,
condenser, connection tubes) will be done
with a soft brush or with the vacuum-cleaner.
During this operation, please take care not to
distort the tubes or detach the cables.
Do not use scouring or abrasive materials !

After having finished the cleaning, replace

the accessories at their places and plug in the
appliance.

Replacing the interior light bulb

If the lamp burns out, disconnect the
appliance from the mains. Take out the
lamp trim. Make sure the lamp is
screwed correctly. Plug in the appliance
again. If the lamp still does not go on,
replace it with another one model E14-
15W . Mount back the lamp trim in its
place.

D ef ects fi n d i ng g u i de

T h e a p p l i a n c e d o e s n o t w o r k .

There is a power failure.

The plug of the supply cord is not inserted
well into the socket.

The fuse is blown.

The thermostat is in „OFF” position.

T h e t e m p e r a t u r e s a r e n o t l o w
e n o u g h
( r e d L E D o n ) .

The food prevents the door closing.

The appliance was not placed correctly.

The appliance is placed too close to a heat
source.

The thermostat knob is not in the correct
position.

E x c e s s i ve i c e b u i l d - u p

The door was not closed properly.

T h e i n s i d e l i g h t i n g d o e s n o t w o r k

The lamp is blown. Unplug the appliance
from the mains, take out the lamp and
replace it with a new one.

T h e f o l l o w i n g a r e n o t d e f e c t s

Possible noddings and cracks coming

from the product: circulation of the
refrigerant in the system.

6

GB

Instruction for use

Advertising