Pioneer VSX-418 S - Manuale (Pagina 21)

Controls and displays 04
21
En
English
Français
Deutsch
Nederlands
Italiano
Español
8 Number buttons and other component
controls
Use the number buttons to directly select a
radio frequency (page 33) or the tracks on a
Pioneer DVD/DVR units. There are other
buttons that can be accessed after the
RECEIVER button is pressed. (For example
MIDNIGHT , etc.)
TUNER DISP*
Switches between named station presets
and radio frequencies (page 34).
CLASS*
Switches between the three banks
(classes) of radio station presets (page 34).
MPX*
Switches between stereo and mono
reception of FM broadcasts. If the signal is
weak then switching to mono will improve
the sound quality (page 33).
D.ACCESS*
After pressing, you can access a radio
station directly using the number buttons
(page 33).
MIDNIGHT
Switches to Midnight or Loudness
listening
(page 27).
ANALOG ATT
Attenuates (lowers) the level of an analog
input signal to prevent distortion.
DIMMER
Dims or brightens the display.
SLEEP
Press to change the amount of time before
the receiver switches into standby (
30 min
– 60 min – 90 min – Off ). You can check
the remaining sleep time at any time by
pressing
SLEEP once.
SIGNAL SEL
Use to select an input signal (page 29).
EON*
Use to search for programs that are
broadcasting traffic or news information
(page 36).
9 INFO
Displays additional EPG information o n a
DVD/DVR.
10 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (
* ) in this section.
11 Remote control LED
Lights when a command is sent from the
remote control.
12 SOURCE
Turns on or off the power of the Pioneer DVD/
DVR units when
DVD or DVR is selected using
the MULTI CONTROL buttons.
13 RECEIVER
Switches the remote to control the receiver
(used to select the green commands above
the number buttons (
SETUP , etc)). Also use
this button to set up surround sound
(page 30).
14 TV CONTROL buttons
These buttons can control only be used with
Pioneer flat screen TVs.
Use to turn on/off the power of the TV.
INPUT SELECT
Use to select the TV input signal.
TV CH +/–
Use to select channels.
TV VOL +/–
Use to adjust the volume on your TV.
VSX_418_MY.book 21 ページ ２００７年１２月２７日 木曜日 午後４時３３分