Pioneer VSX-418 S - Manuale (Pagina 14)

Connecting up 03
14
En
Connecting the speakers
A complete setup of six speakers (including the
subwoofer) is shown below, but everyone’s
home setup will vary.
Simply connect the
speakers you have in the manner shown below.
The receiver will work with just two stereo
speakers (the front speakers in the diagram)
but using at least three speakers is
recommended, and a complete setup is best for
surround sound.
If you’re not using a
subwoofer, change the front speaker setting
(see
Speaker setting on page 30) to LARGE .
Make sure you connect the speaker on the
right to the right terminal and the speaker on
the left to the left terminal. Also make sure the
positive and negative (
+ / – ) terminals on the
receiver match those on the speakers. You can
use speakers with a nominal impedance
between 6
Ω to 16 Ω (please see Switching the
speaker impedance on page 40 if you plan to
use speakers with an impedance of less than
8
Ω ).
Be sure to complete all connections before
connecting this unit to the AC power source.
Bare wire connections
Front speaker terminals:
1 Twist exposed wire strands together.
2 Loosen terminal and insert exposed wire.
3 Tighten terminal.
Center and surround speaker terminals:
1 Twist exposed wire strands together.
2 Push open the tabs and insert exposed
wire.
3 Release the tabs.
1 2 3
10 mm
1 2
10 mm
3
R L
IN CD
IN
OUT
DVD / BD
TV
/ SAT
FRONT
DVD5.1
CH INPUT
IN
IN
DVR
/ VCR
DVR
/ VCR IN
TV / SAT IN
DVD
/ BD IN
AM
LOOP
DIGITAL IN
CEN-
TER
SUB
WOOFER
SURROUND
DVD 5.1CH INPUT
R L
OPT
FM UNBAL
ANTENNA
DVR / VCR OUT
MONITOR OUT
AUDIO VIDEO
IN
OUT COAX
(DVD / BD)
CD-R
/ TAPE / MD
(ASSIGNABLE)
1
(CD)
1
COAX
(DVR/ VCR) 2
DIGITAL IN (ASSIGNABLE)
R FRONT SURROUND CENTER R L L
S
P
E
A
K
E
R
S
SUB
WOOFER
PREOUT
SW L R
C
LS RS
Powered subwoofer Front speakers Surround speakers Center speaker
VSX_418_MY.book 14 ページ ２００７年１２月２７日 木曜日 午後４時３３分