Schreiber Chillers 500AC U Chiller Control - Manuale (Pagina 59)

SPECIAL FEATURE
Automatic Water Level Control
This unit is equipped with an automatic water fill line. The water inlet line for the
automatic water fill is located on the control panel end of the unit and is marked "Tank
Fill". You install your water supply line to this 1/2" female N.P.T. fitting.
When the unit installation is completed, you open the water supply line to the chiller.
When the disconnect is turned on the 24V water solenoid will open, allowing water to fill
the chiller's water reservoir. When the water in the chiller reservoir reaches the proper
level the float switch in the reservoir will cause the solenoid valve to close. This system
will maintain the proper water level at all times. Make sure you keep the water supply
valve open.
For replacement parts see the parts list in this manual for more information.
DO NOT FILL THE WATER TANK WITH DEIONIZED WATER
Kit Number: K08.1P