Pioneer DV-300-K - Manuale (Pagina 10)

Connections 02
10
En
Chapter 2
Connections
Easy connections
Important
• Before making or changing any connections, switch off the power and disconnect the power
cable from the AC outlet.
• The setup described here is a basic setup that allows you to play discs using just the cables
supplied with the player. In this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protection technology. Do not connect this player to your
TV via a VCR using audio/video or S-video cables, as the picture from this player will not
appear properly on your TV. (This player may also not be compatible with some combination
TV/VCRs for the same reason; refer to the manufacturer for more information.)
• When connecting to your TV as shown above, do not set the Component Out setting (See
Video Output settings on page 32) to Progressive .
1 Connect the VIDEO OUT and AUDIO
OUT L/R jacks to a set of audio/video
inputs on your TV.
Use the supplied audio/video cable,
connecting the red and white plugs to the
audio outputs and the yellow plug to the video
output. Make sure you match up the left and
right audio outputs with their corresponding
inputs for correct stereo sound.
See below if you want to use a component or
SCART cable for the video connection.
2 Connect the supplied AC power cable
to the AC IN inlet, then plug into a power
outlet.
Note
• Before unplugging the player from the
power outlet, make sure you first switch it
into standby using either the front panel
STANDBY/ON button, or the remote
control, and wait of the -OFF- message to
disappear from the player’s display.
• For the above reasons, do not plug this
player into a switched power supply found
on some amplifiers and AV receivers.
DIGITAL AUDIO OUT
L
R
P R
P B
Y
COAXIAL
COMPONENT VIDEO OUT
AUDIO OUT
AV CONNECTOR (RGB) TV/AV Receiver
VIDEO OUT
AC IN
To audio/video inputs
To power outlet
Yellow
White
Red
TV
DV300_WY_EN.book 10 ページ ２００７年１月２５日 木曜日 午後７時２３分