03 quick surround sound setup, Vsx-d912 only), Quick surround sound setup – Pioneer VSX-D912 Manuale d'uso

Pagina 14: Quick surround sound setup 03, Chapter 3

Advertising
background image

Quick surround sound setup

03

14

En

Chapter 3:

Quick surround sound setup

VSX-D912 only

Automatically calibrating
your listening area (MCACC)

The Multi-Channel Acoustic Calibration
(MCACC) system measures the acoustic
characteristics of your listening area, taking
into account ambient noise, speaker size and
distance, and tests for both channel delay and
channel level. After you have set up the
microphone provided with your system, the
receiver uses the information from a series of
test tones to optimize the speaker settings
and equalization for your particular room.

• These test tones can be loud, so take care

that there is no one in the room who will
be startled by the noise.

• Make sure the mic and speakers are not

moved during the MCACC setup.

1

Connect the microphone to the SETUP

MIC jack on the front panel.

2

Place the microphone at your normal

listening position.

Place the mic about ear level at your normal
listening position using the supplied micro-
phone stand on a table or chair.

Make sure there are no obstacles between the
speakers and the microphone.

3

If the receiver is off, press

STANDBY/ON to turn the power on.

The

STANDBY

indicator goes out.

4

If you have a subwoofer, turn it on.

5

Press RECEIVER.

6

Press MCACC SETUP.

Try to be as quiet as possible after pressing

MCACC SETUP

. The system outputs a series

of test tones to establish the ambient noise
level.

If the noise level is too high,

NOISY!

blinks in

the display for five seconds. To exit and check
the noise levels again, press

MCACC SETUP

(see the notes regarding ambient noise levels
below) or press

ENTER

when you’re prompted

to

GO NEXT?

The system now checks the microphone and
your speaker setup.

If you see an

ERR

message in the display,

there may be a problem with your mic or the
speaker connections.

Turn off the power, and check the problem
indicated by the

ERR

message (see below),

then try the auto surround setup again.

ERR MIC

– Check the microphone

connection.

MCACC

SETUP

ENTER

RECEIVER

VSX_712_812_912.book 14 ページ 2003年2月6日 木曜日 午前10時51分

Advertising
Questo manuale è associato alle seguenti prodotti: