Marantz PM4001OSE - Manuale (Pagina 8)

3
ENGLISH
CONNECTIONS
WIRING SPEAKER CABLE
• Be careful not to short circuit in wiring speaker cables.
• Peel off the corting of speaker cable as shown below.
• Wiring with speaker cable.
Approx. 1 cm
Cut the corting of
cable. Twist
conductors.
Turn counter-clockwise
to loosen. Insert conductor
of cable. Turn clockwise
to tighten.
CONNECTION OF TUNER
Connect the output jacks of your stereo tuner to the TUNER
jacks of this unit.
CONNECTION OF COMPACT DISC PLAYER
Connect the output jacks of your CD player to the CD jacks of
this unit.
CONNECTION OF TURNTABLE
Connect the L (Left) output cord of the turntable to the “L”
PHONO jack of this unit, and connect the R (Right) output cord
to the “R” PHONO jack. Also be sure to connect the turntable’s
grounding wire to the GND jack of this unit. The GND jack does
not have to be connected if the turntable is not provided with a
grounding wire.
The cartridge of the connected turntable should be of the MM
type. To use a turntable with an MC type cartridge, it is re-
quired to use a step-up transformer.
CONNECTION OF MD or TAPE DECK etc.
Connect the IN (recording input) jacks of the MD or tape deck
to the RECORDER 2 OUT jacks of this unit, and connect the
OUT (playback output) jacks of the MD or tape deck to the
RECORDER 2 IN jacks of this unit.
CONNECTION OF CD recorder etc.
Connect the IN (recording input) jacks of the CD recorder to the
RECORDER 1 OUT jacks of this unit, and connect the OUT
(playback output) jacks of the CD recorder to the RECORDER
1 IN jacks of this unit.
CONNECTION OF SPEAKER SYSTEMS
This unit is equipped with two sets of SPEAKER SYSTEM
terminals––SYSTEM 1 terminals and SYSTEM 2 terminals.
Usually connect your speaker system to the SYSTEM 1
terminals.
• The speakers in the speaker system should have an imped-
ance between 8 and 16 ohms. If speakers with an impedance
of less than 8 ohms are connected, the protection circuitry
may be activated during play.
• Connect the Right channel speaker to the R terminals, and
the Left channel speaker to the L terminals.
• The output terminals have positive (+: Red) and negative
(–: Black) polarity, and each speaker also has the same
polarity (+ and –). When connecting the speaker, be sure
to connect the terminals with the same polarity (+ with +,
– with –).
Peel off the edge
of cable.
05.7.6, 0:06 PM Page 3