Before use, Í equipment mains working setting, Í copyright – Marantz PM4001OSE Manuale d'uso

Pagina 6: Í do not locate in the following places, Í keep objects off, Í battery handling, Í accessories check

Advertising
background image

1

ENGLISH

This section must be read before any connection is made to
the mains supply.

í Equipment mains working setting

Your Marantz product has been prepared to comply with the
household power and safety requirements that exist in your
area.
PM4001 can be powered by 230V AC only.

í Copyright

Recording and playback of any material may require consent.
For further information refer to the following:
— Copyright Act 1956
— Dramatic and Musical Performers Act 1958
— Performers Protection Acts 1963 and 1972
— Any subsequent statutory enactments and orders

í Do not locate in the following

places

To ensure long-lasting use, do not locate the PM4001 where:
• Exposed to direct sunlight.
• Near to sources of heat such as heaters.
• Highly humid or poorly ventilated.
• Dusty.
• Subjected to mechanical vibrations.
• On wobbly, inclined or otherwise unstable surfaces
• Radiated heat is blocked such as in cramped audio racks.
To ensure proper heat radiatizN, ensure the below clearance
from walls and other equipment.

í Keep objects off

Keep objects off the PM4001. Blocking the vent can result in
accident and damage.

BEFORE USE

Left
0.2 m or more

Above
0.2 m or more

Right

0.2 m or more

Rear

0.2 m or more

í Do not touch hot spots during and

Immediately after use

During and immediately after use, the PM4001 is hot in areas
other than the controls and rear panel connection jacks. Do
not touch hot spots and especially the top panel. Contact with
hot areas can cause burns.

í Battery handling

Improper use of dry cell batteries can result in electrolyte leaks,
rupture and corrosion. Read the following precautions before
use.
• If not planning to use the remote controller for an extended

period of 1 month or more, remove the batteries.

• Do not mix old batteries with new batteries.
• Load batteries in the proper direction indicated on the re-

mote controller.

• Do not mix batteries of differing type. Even batteries of the

same shape and size can have differing voltages.

• If batteries leak, wipe the case clean of any adhering elec-

trolyte and replace the old batteries with new batteries.

í Accessories check

Before use, check the below accessories were included in the
package.

• Remote control unit (RC4001PM)

• Size “AA” batteries x 2

• User Guide

• Registration Card

05.7.6, 0:06 PM

Page 1

Advertising
Questo manuale è associato alle seguenti prodotti: