SmartSystem Arm X1 Stabilization Arm - Manuale (Pagina 22)

Remember that the 5/8" pin-axis of your arm must be as much parallel as possible to your
body axis.
Left / Right handed set up
The arm can be used either by right or left-handed operators.
For this reason, it is possible to change the arm's working side very quickly and easily.
Using the supplied key n.5, loosen the tilt adjustment screws and remove the screw that
holds the mating block bolted to the Arm. Remove the bent bracket [A] which preloads the
spring in the joint of the mating block. Flip the mating block side [B] and replace back the
22