Parkside PWSZ 125 A1 - Manuale (Pagina 2)

Safety instructions for steel brushes
Please note that steel brushes lose steel
pieces during normal use. Do not apply
too much pressure to steel brushes. Failure
to heed this warning may lead to injury due to
flying steel pieces.
When the use of a safety cover is recommended,
prevent the safety cover and steel brush from
coming into contact with one another. Please note
that the diameter of disk brushes and cup brushes
can increases due to pressure and centrifugal
force.
§ Meaning of symbols
Not approved for hand-held
or manually-guided grinding
Not approved for wet
grinding
Not approved for side
grinding
Do not use if damaged
Only approved with a
backing pad
Only approved for wet
cutting
Heed all safety instructions
Use protective eyewear
Wear a safety helmet
Use ear protection
Wear safety gloves
Use a dust mask
Unplug
Only for roughing / Only for
grinding
Not for roughing
Only for cutting
The safety cover must be attached to
the power tool and adjusted so that
maximum safety is guaranteed, that is,
as little of the grinding wheel as possible
is open toward the operating individual.
The purpose of the safety cover is to shield the
operating individual from broken pieces or
accidental contact to the grinding wheel.
Grinding wheels may be used only for
their intended purpose. For example, never
grind using the side of a cutting disk. Cutting disks
are intended to cut materials using the disk edge
only. Applying pressure to the side of the disk may
cause it to break.
Always use undamaged clamping flanges
of the right size and proper form for the
grinding disk you’ve selected for use. The
right flange supports the grinding disk and thus
minimizes the risk of it breaking. Flanges for cutting
disks may differ from flanges for grinding disks.
Safety instructions for cut-off grinding
Avoid your cutting disk from blocking
and do not apply too much pressure.
Overstressing the cutting disk increases its
risk of jamming or blocking and thus the likelihood
of kickback or damage to the attachment itself.
Avoid the area directly in front of and
behind the rotating cutting disk. When
moving the cutting disk across your workpiece
away from your person, the tool may be hurled in
your direction in the event of kickback.
Turn off the device is the cutting disk jams
or if you wish to interrupt working. Hold
the device calmly and allow all rotating parts to
come to a complete stop. Never attempt to pull
any rotating parts from the cutting site. This may
cause kickback.
Do not turn on the device while it is still in
the workpiece. Your cutting disk should reach
its full speed before you continue angle grinding.
Otherwise the disk may jam, jump back from the
workpiece and cause kickback.
Support boards and large workpieces
to prevent the risk of kickback due to a
jammed cutting disk. Large workpieces may
bend due to their own weight. Support large
workpieces on both ends and near the cutting site.
Exercise extreme caution when cutting
into existing walls and other areas where
vision is limited. Your cutting disk may kickback
if it comes into contact with gas, water and
electrical lines or other objects.
Safety instructions for grinding with
sandpaper
Heed the manufacturer’s instructions for all
sanding sheet sizes. Do not use sanding sheets that
are too large. Sanding sheets that extend over the
disk can lead to injury and blocking. The sanding
sheet may also tear, causing kickback.
Not for cutting
Not approved for working
with metals
§ Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
GB/MT GB/MT GB/MT
IAN 90985 - PWSZ 125 B2
OWIM GmbH & Co. KG
Stiftsbergstraße 1
D-74167 Neckarsulm
Model No.: Z31680A, Z31680B, Z31680C, Z31680D
Version: 07/2013