Proel WM600D - Manuale (Pagina 6)

6
INTRODUCTION
Thank you for choosing this PROEL product and for your trust in our brand, synonymous of professionalism,
accuracy, high quality and reliability. All our products are CE approved and designed for continuous use in
professional systems.
DESCRIPTION
The WM600D Wireless Microphone System is a DUAL CHANNEL, UHF, PLL controlled frequency device, which
provides a reliable, high quality signal transmission.
WM600D Wireless Microphone System features 3 units: WM600D dual channel receiver, WM6M handheld
transmitter and WM6H body pack transmitter. The system is available in three different configurations, each
of them including an ABS carrying case:
WM600DM: WM600D + 2 x WM6M
WM600DH:
WM600D + 2 x WM6H + lavalier + headset
WM600DKIT: WM600D + WM6M + WM6H + lavalier + headset
Four frequencies are available for each channel, which have been accurately selected to allow the
simultaneous use of 2 devices (four channels in total) without interference between them:
1.
863.100 MHz
2. 863.900 MHz
3. 864.500 MHz
4. 864.900 MHz
WM600D RECEIVER
See FIG. 1 at page 15:
1.
DC IN
Socket for the AC/DC adaptor connection, use only the adaptor supplied with the system.
2. OUTPUT (UNBALANCED)
Unbalanced output with line level: connect it through a mono 6.3mm jack cable to a mixer input.
3. OUTPUT (BALANCED)
Balanced output with mic level: connect it through a XLR cable to a mixer input.
4. POWER
On/off switch.
5. ON
Red LED: if lighted states that the power supply is present and the receiver is turned on.
6. RF (channel A or B)
Green LED: if lighted states that the transmitter is sending a radio signal to the receiver.
7. AF (channel A or B)
Red LED: illuminates when an audio signal is present.
8. SET (channel A or B)
Keep this button pressed until the number flashes and then push it again to set the frequency (1 – 4).
NOTE: when a frequency is selected in one of the two channels, it is not available for selection in the
other one, in order to not create interferences.
9. FREQUENCY NUMBER (channel A or B)
The display shows the frequency number (1 – 4), that must correspond to the frequency set on the
transmitter.