Campomatic DW646BI - Manuale (Pagina 26)

ENDING THE PROGRAMME IN ADVANCE
CARE AND MAINTENANCE
If for any reason you decide to suspend the programme, you can do so by following the
instructions.
Press and hold (about 5 seconds) the key . The display will show "0", and the machine
will run a drain phase. A beep will signal the end of the cycle.
You can open the door by following the previous instructions.
For reprogramming, turn the machine off and back on again using the ON/OFFbutton.
Then proceed with re-programming.
Before proceeding with this operation, make sure that the dishwasher is
disconnected from the electrical power supply and that a wash cycle has not just ended
(otherwise the inside of the tub might still be hot)
To keep the dishwasher working efficiently, you will need to clean the filter assembly
regularly.
To clean the filter assembly proceed as follows:
Turn filter 1 counter-clockwise and pull it out of its housing.
Filter and micro-filter
• Extract and take out the stainless steel filter and micro-filter
•
24