Bompani BOMPxxx - Manuale (Pagina 16)

969 16
Positioning and installing the appliance
A
B
2
D E 3
1
GB
REMOVING THE TRANSPORT PROTEC-
TION DEVICES
Check that the appliance is undamaged.
The retailer must be informed of any damage to the appli-
ance within 24 hours of delivery.
1 Remove the protection from the door gasket.
The protection is used to protect the gasket during
transport.
The protection must be removed in order to ensure
that the door seal functions correctly.
To remove the protection, lightly pull one end while
rotating it outwards.
2 Remove the glass shelf locking devices.
These plastic elements prevent the shelves from
moving during transport.
To remove the shelf locking devices, proceed as fol-
lows:
a) Grasp the plastic locking device and rotate it until
it comes away from the shelf.
b) Remove the locking device by pulling it outwards.
3 Level the fridge by adjusting the feet.
WHEN INSTALLING THE APPLIANCE,
REMEMBER THE FOLLOWING:
A Do not install it near to sources of heat such as heat-
ers, radiators, cookers, etc. or in direct sunlight.
B Position the appliance in a dry well-ventilated location.
C Do not install the appliance in non-ventilated spaces
such as wall niches.
D During automatic defrosting, make sure that the water
fl owing along the cell back wall is conveyed into the
discharge channel.
E If the appliance is supplied with spacers, fi t them to
the upper part of the condenser on the back.
F After the appliance has been placed in its fi nal position,
leave it for about an hour before connecting it to the
power supply.
G Make sure that the appliance is working properly
before placing any food in it.
H Leave a space of at least 5 cm between the top of the
appliance and any wall cupboards.
I Some appliances are fi tted with rear wheels to enable
them to be moved easily.
WARNING: DO NOT INSTALL THE APPLIANCE
NEAR TO ANY HEAT SOURCES AND LEAVE A GAP
OF AT LEAST 5 CM ABOVE IT