VDO M2WL - Manual (Page 19)

19
M2 WL
“Language” appears on the display.
Press the
BIKE button to scroll to the setting for the total
distance.
Settings – setting the total distance
Press the SET button to open the setting.
The left digit flashes.
Press the BIKE button to change the digit.
Once this digit has been set, confirm the setting
by pressing the
SET button.
The next digit starts to flash and is ready to be set.
Press the BIKE button to change this digit.
Once this digit has also been set, confirm the setting
by pressing the
SET button.
The next digit flashes.
Once all digits have been set, confirm the setting again by
pressing the
SET button.
The response “Set Ok” appears on the display.
The set value is stored.
If you want to configure further settings,
press the
BIKE button to access these.
If you do not want to configure any other settings,
press and hold the SET button.
The settings menu closes.
The VDO M2 WL returns to function mode.
You can set the total distance ridden on the VDO M2 WL. For
example, you can enter your data here at the start of a new
cycling season.
ATTENTION: the M2 WL has a data memory.
No data is lost when the battery is replaced.
The process is as follows:
Press and hold the SET button until the settings menu
opens.