Studiologic Numa Organ 2 - Manuale (Pagina 18)

NUMA ORGAN 2 by Studiologic® 18
Operation
To create your favourite sound, you can move through all the para-
meters on the control panel. Once you find the right combination,
you can store the obtained sound in one of the 11 keys of the re-
versed octave, by following the procedure below:
- Press the Preset/[Sound] button on the panel, to switch it on (LED
status: ON);
- Keep pressing for a few seconds the Preset key in the reversed
octave, where you want to store the current sound and panel setup;
- Wait until the related LED flashes, confirming that the sound is sto-
red in the selected Preset.
Note: the B key is a Panel control and the related location is not storable
as preset, but it keeps the Sound (Model) B as a default sound and it is set
to the actual configuration of all controls (drawbars and all other panel’s
switches and potentiometers).
Note: the instrument stores all effect controls and settings in any Preset.
The Numa Organ 2 can reproduce sounds of different vintage or-
gans. The technology of the sound engine can emulate different
sound models as explained in the Introduction at pages 7,8.
To select the different sound models, follow the procedure below:
- Keep pressing the Preset/[Sound] button until it flashes (LED sta-
tus: FLASH);
- Select the Sound Model from the list below:
Sound 1 (C): Classic Organ Principal (Diapason Pipe Partials)
Sound 2 (C#): empty
Sound 3 (D): Electronic Organ Model V (Mellow Triangle)
Sound 4 (D#): empty
Sound 5 (E): Electronic Organ Model D (Sweet Square)
Sound 6 (F): Electronic Organ Model F (Smooth Sawtooth)
Sound 7 (F#): empty
Sound 8 (G): Tone wheel Organ Model C (C3-G)
Sound 9 (G#): empty
Sound 10 (A): Tone wheel Organ Model A (A100-A122)
Sound 11 (A#): empty
Sound 12 (B): Tone wheel Organ Model B (B3)
Note: this list could be updated with future sound implementations.l
- To escape the Sound Selection function press again the Preset/
[Sound] button (LED status: ON/OFF).
Note: during the Sound Selection procedure it’s always possible to use the
Drawbars and any other effect and/or control; if you want to store the se-
lected Sound together with the current panel setup, follow the Preset Store
Procedure above.
Preset Store
Sound Selection