Atlantis Land DiskMaster NASG302D - Manuale (Pagina 40)

ENGLISH
DiskMaster 40
1.8 Hardware Installation
Following is a quick installation guide to get you up and running. For further
details on each of the settings, please refer to manual on CD.

Release two screws from the back side.

Remove the aluminium plate.

Release the 4 screws in the Hard Disk Mount.

Place the first Hard Disk in to lower mont.

Place the second Hard Disk in the upper area.

Fasten all Hard Disk screws.

For SATA Hard Disk: connect both power cable and data cable in
to Hard Disk. For Eide Hard Disk: connect pwer cable and IDE
cable in to Hard Disk, set jumper in Master mode and Slave mode
when install 2 HD.

Slowly put the Hard Disk mount back to case.

Fasten the 4 screws.

Fasten the Aluminium plate screws.

Please use the ethernet cable to connect the device and the
Router/Switch in the network.

Please turn on the Power Switch.
Please check the following pictures.