Maintenance and care – Hotpoint Ariston Experience FY 610 IX-HA Manuale d'uso

Pagina 19

Advertising
background image

19

GB

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply

before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external parts as

well as the rubber seals may be cleaned using a

sponge that has been soaked in lukewarm water and

neutral soap. If these stains are difficult to remove,

use only specialised products. After cleaning, rinse

and dry thoroughly. Do not use abrasive powders or

corrosive substances.

• Ideally, the inside of the oven should be cleaned after

each use, when it is still lukewarm. Use hot water and

detergent, rinse and dry with a soft cloth. Do not use

abrasive products.

• All accessories - with the exception of the sliding

racks - can be washed like everyday crockery, and

are even dishwasher safe.

• Never use steam cleaners or pressure cleaners on the

appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge

and a non-abrasive cleaning product, then dry

thoroughly with a soft cloth. Do not use rough abrasive

material or sharp metal scrapers as these could scratch

the surface and cause the glass to crack. To clean more

thoroughly, you can remove the oven door.

1. Open the oven door fully (see diagram).

2. Lift up and turn the small levers located on the two

hinges (see diagram).

3. Grip the door on the two

external sides and close it

approximately half way. Unlock

the door by pressing on the

clamps F

F

F

F

F

, then pull the door

towards you lifting it out of its

seat (see diagram).

To replace the door, reverse this

sequence.

Inspecting the seals

Check the door seals around the oven periodically. If

the seals are damaged, please contact your nearest

After-sales Service Centre (see Assistance). We

recommend not using the oven until the seals have

been replaced.

Replacing the light bulb

To replace the oven light bulb:

1. Remove the glass cover of the lamp-holder.

2. Remove the

light bulb and

replace it with a

similar one:

Wattage 25 W, cap

E 14.

3. Replace the

glass cover (see
diagram

).

F

F

Advertising