11 additional information, Troubleshooting, Additional information – Pioneer VSX-D714 Manuale d'uso

Pagina 69: English italiano français, Nederlands, Español deutsch, Additional information 11, Chapter 11

Advertising
background image

Additional information

11

69

En

English

Italiano

Français

Nederlands

Español

Deutsch

Chapter 11:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.

Problem

Remedy

The power does not turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your

nearest

Pioneer authorized service center or your dealer for servicing.

No sound is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 15).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

MASTER VOLUME

.

No image is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 15).

• Select the correct component (use the

MULTI CONTROL

buttons).

Considerable noise in radio
broadcasts.

• Tune in the correct frequency.
• Connect the antenna (refer to page 20).
• Route any loose cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 20).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 20).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.

VSX_714_814.fm 69 ページ 2004年1月28日 水曜日 午前10時18分

Advertising