11 additional information, Troubleshooting, Additional information – Pioneer VSX-D912 Manuale d'uso

Pagina 70: Additional information 11, Chapter 11

Advertising
background image

Additional information

11

70

En

Chapter 11:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie
in another component. Investigate the other components and electrical appliances being used.
If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest
Pioneer authorized service center or your dealer to carry out repair work.

Problem

Remedy

The power does not turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the

STANDBY

indicator blinks and the power shuts off

automatically, take the unit to your

nearest Pioneer authorized

service center or your dealer for servicing.

No sound is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 16).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

MASTER VOLUME

.

No image is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 16).

• Select the correct component (use the

MULTI CONTROL

buttons).

Considerable noise in radio
broadcasts.

• Tune in the correct frequency.
• Connect the antenna (refer to page 21).
• Route any loose cables away from the antenna terminals and
wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall.
• Connect an outdoor FM antenna (refer to page 21).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to
page 21).
• Turn off the equipment causing the noise or move it away from the
receiver.
• Move antennas farther away from equipment causing the noise.

VSX_712_812_912.book 70 ページ 2003年2月6日 木曜日 午前10時51分

Advertising
Questo manuale è associato alle seguenti prodotti: