Pioneer VSX-D912 - Manuale (Pagina 51)

Setting up 07
51
En
English
Italiano
Français
Nederlands
Español
Deutsch
Setting separate channel
levels for listening modes
• Default setting: 0 dB
In addition to the MCACC setup, you can also
set relative channel levels from the listening
position using the method below. Using
CH
SELECT (see tip below), it is also possible to
set separate channel levels for each of the
listening modes.
1 Press STANDARD or ADVANCED
SURROUND.
2 Press TEST TONE to output the test
tone.
The test tone is output in the following order
(depending on the speaker setting):
• If you don’t hear a test tone from one of
your speakers, please refer to Speaker
setting on page 44 and Surround back
speaker setting on page 45 to make sure
you have correctly specified your speaker
setup.
3 Press MASTER VOLUME +/– to adjust
the volume to an appropriate level.
4 Use LEVEL +/– to adjust the speaker
levels in turn.
You should hear the test tone at the same
volume from each speaker when seated in the
main listening position. The channel level
range is ± 10 dB.
5 When you’re done, press TEST TONE to
turn off the test tone.
The receiver returns to the Standard mode.
• The speaker volume can be adjusted
without outputting the test tone by
pressing
CH SELECT and then using
LEVEL +/– . However, you can only adjust
the level of the speakers currently active
in the mode you’re listening to. You can
set separate levels for the
STANDARD ,
STEREO and DVD 5.1 ch / DVD 7.1 ch
modes, as well as for each ADVANCED
SURROUND mode.
• Test tone is only output in STANDARD or
ADVANCED SURROUND mode.
• Since the subwoofer transmits an ultra-
low frequency its sound may seem quieter
than it actually is.
• Using test tones to set up your speaker
system will overwrite any previous
settings you had for the
STANDARD or
ADVANCED SURROUND modes.
STANDARD SURROUND ADVANCED
LEVEL
TEST
TONE
MASTER
VOLUME
CH
SELECT
L C
RS
R
LS SW SB
VSX_712_812_912.book 51 ページ ２００３年２月６日 木曜日 午前１０時５１分