Auto setup for windows 3.1, windows 95, Windows 98 or windows nt – IBM T 55A Manuale d'uso

Pagina 15

Advertising
background image

9

DEUTSCH

ENGLISH

FRANÇAIS

ESP

A

ÑOL

IT

ALIANO

JAP

ANESE

COMPL & W

ARR

Auto Setup for Windows 3.1, Windows 95, Windows 98 or Windows NT

If the monitor is in standby
mode (STANDBY ON), it

may automatically turn off while
you are waiting for it to warm up.

1.

Turn on the monitor first; then the PC.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:

that the video interface cable is connected properly.

the correct video adapter card is installed.

the correct supported display mode is selected for your PC.

2.

Wait approximately 15 minutes, until the monitor warms up.

3.

Drag the icon bar and tool bar, if they are displayed, to the bottom of the

screen.

4.

Insert the diskette labelled ‘IBM Monitor Installation Disk’ into the

diskette drive.

The size and diversity of
the dot pattern varies with

the screen resolution.

5.

Check the operating system installed on your PC and follow the

instructions from the table below.

6.

When the test pattern appears, press the OSD Enter button

at the

bottom of the monitor to display the initial OSD menu.

Position the mouse pointer
at the bottom center of the

screen. This allows

A

UTO

S

ETUP

to run properly

7.

Use an Arrow button (

or

) to select the

IMAGE LOCK

icon

and press the OSD Enter button

to access the function.

8.

Using an Arrow button (

or

), select

AUTOMATIC

and press the

OSD Enter button

. This activates the

A

UTO

S

ETUP

procedure, which

will optimize the display settings with the provided test pattern.

The screen will dim, blink on and off several times, and you may notice

small changes to the test pattern.

To abort the

A

UTO

S

ETUP

function, press the

E

SC

key.

9.

When finished, the OSD main menu returns. Press the Exit button

once to exit from the OSD.

Operating

System

Step1

Step2

Step3

Step4

Windows 3.1

Open

P

ROGRAM

M

ANGER

Select

F

ILE

Select

R

UN

Type

A:\TESTPAT

and press

ENTER

Windows NT 3.5

Windows 95

Select
S

TART

Select R

UN

Windows 98

Windows NT 4.0

T55A.book Page 9 Wednesday, September 16, 1998 10:32 AM

Advertising