Proel PLIS1200CN - Manuale (Pagina 8)

Operation experience.
Power on the projectors before the controller. All the projectors in the same communication lines should be powered up in 5 – 10
seconds. Otherwise, the last powered projectors, during their startup, might affect the normal operation of the anterior projectors.
Fire warning.
Flammables materials are not allows to fall in the lamps or the air duct. Otherwise, the high temperature lamps in the lamps might
cause fire. In case of unusual smell or take fire, turn off the power immefdialtely and have the case properly handled fbefore turning
on the lamps again.
MAINTENANCE
Clean the machine, lens, machine interior and computer board regularly.
Fasten the screws and nuts in the hoisting parts and the racks regularly.
Replace lamps according to the actual situation. Do not use inferior quality lamps.
TROUBLE SHOOTING
The lamp does not work
•
Check whether the power supplied is 230 V AC and whether the fuse is burnout.
•
The lamp is not cool enough. Let it cooled down.
• The lamp is in over heat protection status due high interior temperature. Check whether the fan and the air duct are blocked.
• Inferior or aged lamp. Replace the lamp or add ignition coils to aid the ignition.
•
Igniter degradation or poor contact. Replace according to the original circuit.
•
Ballast damaged.
The motors do not work correctly
• Check whether the power supplied is 230 V AC and whether the use is blown.
•
Check whether the motor lines or connecting lines are degraded or broken.
•
Check whether the small flange screws for mechanical fastening is loose, poor in contact, aged or blown.
•
Check whether the output voltage of the transformer is normal.
The communication is out of control
•
Wrong connection of communication lines, unwelded, loose or short the circuit.
• Incorrect address code setting.
•
Communication IC on computer board broken under high voltage.
•
Signal attenuated over excessive long communication line. Add a serial signal amplifier to the communication line of 120 ohm
terminator of the last projector cannon connector.
• Signal or voltage Interference from periphery equipments.
•
Control equipments damaged or incompatible signal.
CONTROL PANEL INFO
First, fir the control-handle device on both sides of the move light, and immobilize it, and insert the panel plug (power+signal) in the
corresponding socket of back plate of the light. Then it’s possible to operate the connecting machine communication. If you use outer
DMX 512 controller, you must pulled out plug at first.
Setting method
The Follow Spot PLIS 1200CN has 4 channels. So if you want to connect one or more projectors, you must respect the following
setting method:
Projector 1 will have got Address No. 1 and Address Code (1=ON)
Projector 2 will have got Address No. 5 and Address Code (1,3=ON)
Projector 3 will have got Address No. 9 and Address Code (1,4=ON)
Projector 4 will have got Address No. 13 and Address Code (1,3,4=ON)
Projector 5 will have got Address No. 17 and Address Code (1,5=ON)
Projector 6 will have got Address No. 21 and Address Code (1,3,5=ON)
…
8