Bompani BOMPxxx - Manuale (Pagina 20)

969 20
Cleaning - Troubleshooting
Green and
Yellow to Earth
Blue to
Neutral
13 amp Fuse
Brown
to Live
Cord Clamp
GB
CLEANING
Before starting any cleaning, disconnect the
appliance from the mains electricity supply.
The protections (wire grill, covers) must not
be removed by unqualifi ed personnel: do not
use the appliance if the protections have been
removed.
WHEN CLEANING THE INTERNAL PLASTIC PARTS AND
THE DOOR GASKEt:
do not use abrasives or detergents of any kind.
- Use a warm solution of bicarbonate of soda (two
spoonfuls in two litres of water).
CLEANING THE CONDENSER
- This should be carried out at least twice a year.
- Clean using a domestic vacuum cleaner or a brush.
A dirty condenser will have a negative effect on the
appliance and reduce its performance.
FOR PROLONGED ABSENCES
- Empty the compartments.
- Disconnect the appliance from the mains electricity
supply.
- Clean both the compartments and dry them.
- Leave the doors open to prevent bad smells or mould
from forming.
CLEANING THE WATER DRAIN
When cleaning the condenser, check that the rear drain
pipe R is not blocked.
- Remove drain pipe R from the container V and if
necessary clean it.
POWER SUPPLY CABLE
- Periodically inspect the power cable to check its
condition.
- If the cable is damaged, do not use the appliance and
do not attempt any repairs. Call a qualifi ed technician
to replace the faulty cable.
ELECTRICAL CONNECTION
Check that the mains voltage complies with that indicated on the
rating plate located on the bottom left of the freezer compart-
ment. If the mains socket does not have an earth connection or
if the plug is not suitable for the mains supply system, refer to
a qualifi ed electrician. Do not use adapters or extension leads,
as these may overheat and burn.
WARNING: THIS APPLIANCE MUST BE EARTHED
If the appliance has been fi tted with a non-rewirable plug of
the incorrect type for the mains socket, cut off the plug and fi t
a new one. The removed plug must be thrown away. Inserting
an unsuitable plug into a 13 Amp socket is likely to cause an
electrical hazard. When a non rewirable plug or rewirable 13
Amp (BS1363) plug is used, it must be fi tted with a 15 Amp
ASTA approved (BS1362) fuse. If any other type of plug is used
it must be wired as follows. Connect the GREEN & YELLOW
wire to the earth terminal marked with the letter “E” or earth
symbol, or coloured green or green & yellow. Connect the
BLUE wire to the neutral terminal marked with the letter “N” or
coloured black. Connect the BROWN coloured wire to the live
terminal marked with the letter “L” or coloured red.