Bompani BO06443/E - Manuale (Pagina 12)

EN -11-
The appliance performs poorly;
Check if;
• You have overloaded the appliance,
• The doors are not closed perfectly,
• There are not enough ventilation ducts on the kitchen unit as mentioned in the Installation
Manual.
If there is noise;
The cooling gas which circulates in the refrigerator circuit may make a slight noise (bubbling
sound) even when the compressor is not running. Do not worry, this is quite normal. If these
sounds are different check if;
• The appliance is installed fi rmly as described in the Installation Manual.
• The objects on the appliance are vibrating.
f there is water in the lower part of the refrigerator;
Check if;
The drain hole for defrost water is not clogged (use defrost drain plug to clean the drain hole).
If your fridge is not cooling enough;
Your fridge is designed to operate in the ambient temperature intervals stated in the standards,
according to the climate class stated in the information label. We do not recommend operating
your fridge out of stated temperatures value limits in terms of cooling effectiveness.
Climate
Class
Ambient Temperature o C
T Between 16 and 43 (°C)
ST Between 16 and 38 (°C)
N Between 16 and 32 (°C)
SN Between 10 and 32 (°C)
Recommendations
• In order to increase space and improve the appearance, the “cooling section” of
refrigerators is positioned inside the back wall of the refrigerator compartment. When
the compressor is working, this wall is covered with frost or water drops. Do not worry.
This is quite normal. The appliance should be defrosted only if an excessively thick ice
layer forms on the back wall.
• If the appliance is not used for a long time (for example during the summer holidays), set
the thermostat knob to position “ “. Defrost and clean the refrigerator leaving the door
open to prevent the formation of mildew and smell.
Conformity Information
• Tropical Class is defi ned for the environment temperatures between 16°C and 43°C in
accordance with the TS EN ISO 15502 Standards.
• The appliance is designed in compliance with the EN15502, IEC60335-1 / IEC60335-2-
24, 2004/108/EC standards.