dB TECHNOLOGIES DSX 2040 - Manuale (Pagina 14)

E
n
g
lis
h
25
E
n
g
lis
h
26
Filter configuration Low crossover point High crossover point
None FTRL Off FTRH Off
Highpass FTRL not Off FTRH Off
Lowpass FTRL Off FTRH not Off
Bandpass FTRL not Off FTRH not Off
FRQL FRQH
FRQH
FRQL
6.5 INPUT COMPRESSOR
THRESH:
The compressor threshold ranges from -20 to +20dBu in 0.5dB steps.
ATTACK:
The compressor attack time ranges from 0.3 to 1ms in 0.1ms steps, then ranges from 1 to
100ms in 1ms steps.
RELEASE:
The compressor release time can be set at 2X, 4X, 8X, 16X or 32X the attack time.
RATIO:
The compressor ratio is the slope in which the signal is compressed. It ranges from 1:1 to
1:40.
6.6 INPUT/OUTPUT CHANNEL NAME
NAME:
A 6 characters name can be assigned to each channel.
O1: ______ C omp
THRESH:+20.0dB
O1: ______ Comp
ATTACK:10ms
O1: ______ Comp
RELEASE:8X Atck
O1: ______ Comp
R ATIO : 1:1
I1: ______ Name
NAME: ______
6.7 OUTPUT LIMITER
THRESH:
The limiter threshold ranges from -20 to +20dBu in 0.5dB steps.
ATTACK:
The limiter attack time ranges from 0.3 to 1ms in 0.1ms steps, then ranges from 1 to 100ms
in 1ms steps.
RELEASE:
The limiter release time can be set at 2X, 4X, 8X, 16X or 32X the attack time.
6.8 OUTPUT SOURCE
IN1-2:
This sets the input channel source for the current output channel. It can be used to mix the
input source (in dB) or disable it (Off). If more than one input sources are enabled, they will
be added together as the source for the current output channel.
7.0 OPERATING THE SYSTEM MENUS
The System Menus allow the user to control and change parameters that are related to the
system behavior and general operation. It can be accessed by pressing the Sys key in the
main menu (when no Input/Output or System Menu is activated). All System Menus
require pressing the Enter key to confirm and save the settings.
7.1 PRESET RECALL
The DSX 2040 has a built in non-volatile memory that can store up to 30 different preset
setups.
P:
This control selects which program to recall from the non-volatile memory. The program
name is displayed to the right of the program no.
O1: ______ Source
I N 1: Off
O1: ______ Source
I N2 : - 14.00
O1: ______ Limit
THRESH:+20.0dB
O1: ______ Limit
ATTACK:10ms
O1: ______ Limit
RELEASE:8X Atck
SYSTEM Recall
P:1 ____________