Indesit IS79C - Manuale (Pagina 15)

GB
15
Dryer Description
Note: If the water container fills the indicator lights,
the heat is turned off and your laundry will not dry.
The On/Off indicator light signals that your dryer is
in use or ready to select a programme. If this light flash-
es it indicates there is a fault (
see Troubleshooting ).
The ON/OFF button : If the dryer is running and this
button is pressed, the dryer stops. Press again, the
dryer restarts.
The Progress or Delay lights show you the status of
the programme, or the delay time when they flash.
During a delayed start, the lights will flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (
see Start and Programmes ).
The PROGRAMMES knob sets the programme: rotate
it until the indicator is pointing to the programme you want
to select (
see Start and Programmes ).
The START/CANCEL button starts a selected
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. If you have not set a programme, the buzzer
will beep four times. When a programme is running,
holding this button in cancels the programme and stops
the dryer (
see Start and Programmes ).
The OPTION buttons/lights select available options for
your selected programme ( see Start and Programmes ).
The lights indicate that the option has been selected.
The Programmes Guide allows you to consult a user
friendly table of the available programmes.
The Empty Water light signals that the water
container should be emptied. When it is flashing it
indicates that the container is full.
The light will take a few seconds to go out after
replacing the empty water container, the dryer must
be running for this to happen (
see The Controls ).
Control panel
Empty Water
Light
Programmes Guide
PROGRAMMES
Knob
START/CANCEL
Button
Indicator
OPTION
Buttons and lights
Progress or Delay
Lights
On/Off
Light
ON/OFF
Button
To open the door The features
Water container
Air intake
grille
Rating plate
Filter
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover
Press and release the front
panel in position shown
Condenser unit
(Cover open)