Brother HL-1850 - Manuale (Pagina 199)

APPENDICE
A–29
IMPORTANT - Wiring Information (solo per il Regno Unito)
If the power cord supplied with this printer is not suitable for your electrical
outlet, remove the plug from the mains cord and fit an appropriate three-pin
plug. If the replacement plug is intended to take a fuse then fit a fuse with
the same rating as the original.
If a moulded plug is severed from the power cord then it should be destroyed
because a plug with cut wires is dangerous if plugged into a live socket
outlet. Do not leave it where a child might find it.
In the event of replacing the plug fuse, fit a fuse approved by ASTA to
BS1362 with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE PROPERLY EARTHED.
The wires in the mains cord are coloured in accordance with the following
code:
Green and yellow: Ground
Blue: Neutral
Brown: Live
The colours of the wiring in the power lead of this printer may not
correspond with the markings which identify the terminals in your plug. If you
need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the
coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of
the plug permits, leave the green and yellow wire longer than the others so
that, in the event that the cord is pulled out of the plug, the green and yellow
wire will be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter "E" or by the earth
symbol or coloured green or green and yellow.