IBM 9519-AW1 - Manuale (Pagina 18)

11
DE
UTS
C
H
EN
GLI
S
H
F
R
ANÇAIS
ES
P
A
Ñ
O
L
IT
ALIA
NO
JAP
ANE
S
E
COMP
L & W
A
R
R
Auto Setup OS/2
If the monitor is in standby
mode (STANDBY ON), it
may automatically turn off while
you are waiting for it to warm up.
1. Turn on the monitor first; then the PC.
If the message CHECK SIGNAL CABLE is displayed, or if nothing is
displayed check:
• that the video interface cable is connected properly.
• the correct video adapter card is installed.
• the correct supported display mode is selected for your PC.
2. Wait approximately 15 minutes, until the monitor warms up.
3. Insert the diskette labelled ‘IBM Monitor Installation Disk’ into the
diskette drive.
4. Select OS/2 S YSTEM , S YSTEMS S ETUP , S YSTEM . Select S CREEN R ESOLUTION
1280 X 1024 X 256 .
5. Select S CREEN R EFRESH of 60H Z .
6. Close S YSTEMS and restart your system.
7. At the OS/2 command prompt, select the OS/2 F ULL S CREEN command.
8. Press mouse button 2 and select S ETTINGS or P ROPERTIES (depending on
your OS/2 version).
9. Select S ESSION and then choose W IN -OS/2 F ULL S CREEN .
10. Open the OS/2 full-screen window.
11. At the command prompt type A: and press ENTER.
12. Type TESTPATS and press ENTER.
The size and diversity of
the dot pattern varies with
the screen resolution.
13. When the dot pattern appears, press the OSD Enter button to
display the initial OSD menu.
Position the mouse pointer
at the bottom center of the
screen. This allows A UTO
S ETUP to run properly.
14. Use an Arrow button (
-
or
+
) to select the I MAGE L OCK icon and
press the OSD Enter button to access the function.
15. Using an Arrow button (
-
or
+
), select AUTOMATIC and press the OSD
Enter button . This activates the A UTO S ETUP procedure, which will
optimize the display settings with the provided test pattern.
The screen will dim, blink on and off several times, and you may notice
small changes to the test pattern.
(To abort the A UTO S ETUP function, press the ESCAPE key.)