Elektra Beckum none - Manuale (Pagina 3)

5 Installation
Fit the two crosshead plates (370/371) to
the machine housing.
Use 4 each
cup square neck bolt M 6x20
flange nut M 6 Hook roller carriage extrusion (358) with
both extrusion brackets (319 + 320) onto the
crosshead plates. If it is a tight fit remove
some paint from the slots in the extrusion
brackets.
Secure roller carriage extrusion by fixing the
rear extrusion bracket (319) to the crosshead
plate (371), to prevent unhooking.
Use 1 each
hexagen head bolt M 6x16
hexagon nut M 6 Remove the front backstop plate (360) and
slide traversing saddle onto the roller car-
riage extrusion.
The carriage table should be set approx.
0.5 mm higher than the machine table. Set
with setting screws B. Loosen screw
holding rear extrusion bracket (319/371
and 320/370) to bracket before turning
setting screw B and tighten after setting.
Make trial cut to verify proper setting. After
setting is completed, tighten all 4 nuts
(408) M8 (A). Alignment:
Set roller carriage extrusion parallel to the
machine table with both front and rear set-
ting screws C. It does not matter if the
carriage table is higher or lower than the
machine table.
After successful parallel alignment tighten
the counter nuts on all 4 setting screws B. Den Klemmhebel mit Unterlegscheibe durch
den Schlitz der Kulissenschiene führen und
den Stellgleiter aufschrauben.
C
B
A
Reinstall backstop plate. Place sliding carriage table onto traversing
saddle and secure with the lock levers.
Loosely fit two cup square neck screws M
6x20 with washer Ø6.4, spring washer Ø6
and hexagon nut M6 to the two holes in the
front of the carriage table. Slide link bracket extrusion on the heads of
the just fitted cup square neck screws. At this
stage do not tighten the screws.