Proel PLC64AL - Manuale (Pagina 9)

9
Make sure the light power off before you install the lamp or move the equipment.
Don’t use the different power voltage or different kinds of lamp.
During use this light, it may generate high temperature to cause danger. Please
don’t put any inflammable or explosive material near the equipment, don’t touch
the light directly by hand.
Make sure the distance of the equipment and is over 2.5 meters
Don’t look at the lamp directly to avoid eyes injury
INSTALLATION INSTRUCTIONS
This product is fit to be used indoors, its ambient operating temperature lower
than 25°C.
Before the product begins to be used for the first time, please open the package
to check if there are any damages caused during transportation
FITTING / EXCHANGING THE LAMP
- Open the lamp lid (fig.1)
- Remove the ring that lock the lamp (fig.2).
- Insert the electrical connections of the lamp on the lamp holder (fig.3).
- Insert the lamp (fig.4).
- Lock the lamp with the ring (fig.5).
- Close the lamp lid (fig.6)
Before replace the lamp, please make sure the power have been cut off, and wait
until the light cool down (the temperature of the lamp can reach 180°C).