Clay Paky SHADOW - Manuale (Pagina 8)

To enable independent operation of several Shadow projectors each must be
assigned a unique address code. This procedure calls for the presence of an autho-
rized technician.
Projectors are wired up to the controller and one to the next using two-core screened
cable and Cannon 5 pin XLR type plug/socket connectors.
To connect a DMX line, a terminating plug (9) with a 100 Ω resistor wired between
pins 2 and 3 must be fitted to the last projector connected in series; the plug is not
required when using an RS232/423(PMX) signal.
The wires must not come into contact with each other or with the metal casing
of the plug.
The casing of the plug/socket must be connected to the screen and to pin 1 of
the connectors.
SIGNAL
SCREEN
SIGNAL
5 4
3
2 1 DMX
512
SIGNAL
SCREEN
SIGNAL
RS232/423
(PMX)
1 2
3
4 5
Having completed the operations described above, press the on/off switch (10).
Check that the lamp comes on and that the auto-reset sequence starts.
CHANNELS FUNCTION (SHADOW QS) 3
• IRIS - channel 1
0
1
2
3
4
5
6
7
8
9
10
The response of the iris to the move-
ment of the potentiometer is linear and
continuous through the full 0… 100%
range, so that the slider can be
stopped in any position to obtain the
desired aperture diameter.
100%
0%
In the 0% to 50% range of adjustment
the dimmer opens gradually to maxi-
mum aperture. Strobe effect is pro-
duced from 54.7% to 95% with fre-
quency increasing from 1 to 7 flash-
es/second. The aperture remains
fixed from 95% to 100% of the slider
range.
• DIMMER/STOPPER/STROBE - channel 3
• COLOUR WHEEL - channel 2
WHITE
RED
YELLOW
VIOLET
GREEN
ORANGE
BLUE
PINK
0
3
5
7
8
9
6
4
2
1
10
The change of colour in response to
movement of the potentiometer is lin-
ear and continuous, so that the slider
can be stopped in intermediate posi-
tions to obtain a two colour beam.
0
1
2
3
4
5
6
7
8
9
10
- When connected to an external controller, several projectors can be controlled either
simultaneously or independently.
9
10
8
CHANNEL FUNCTION
1 IRIS
2 COLOUR WHEEL
3 DIMMER/STOPPER/ STROBE
4 COLOUR TEMPERATURE CONVERSION
9
Is 1 IRIS
3 DIM
COL 2
STOP
DIM 4
TEMP
The connection between projector and controller must be made using a multicore
cable with 8 wires of 0.25mm
2 section and a DIN 8 pin 45° plug/socket connector.
RS 232/423(PMX) - DMX 512 CONNECTION
- Several Shadow followspots can be controlled simultaneously from the integrated
control panel on one fixture.