Rockwell Automation 931S-A2A2N-DC Active Isolator - Manuale (Pagina 4)

4
3 Mounting and dismounting
3.1 Mounting onto TS 35 DIN rails
(Page 40, Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(Page 40, Fig. 2)
1. Remove connector,
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
The circuit board can only be inserted in one position.
The connectors are keyed to insure proper installation.
3.3 Pluggable cross-connections for voltage supply
(Page 41, Fig. 3)
A maximum feed through of 2 A is possible.
If a signal conditioner is accidently rotated through 180°,
the plug-in jumper cannot be inserted.