Teka EM 30 2P - Manuale (Pagina 21)

GB
21
If something doesn’t work
Fault Possible cause Possible solution
Neither the hotplates nor the pilot lights are working
The cable is not connected
to the mains
Connect the cable
to the mains
There is no spark when the
automatic ignition control is pressed
There is no current at
the plug
Check/repair the electri-
city at the mains
The gas burners are making the pans dirty
The burner openings
are dirty
Clean the burners’
openings
The injector or injector
holder is dirty
Clean the holders injector
and injector without using
anything which could dama-
ge or alter the diameter of
the gas outlet opening
Before calling the Technical Service, please
make the following checks:
There is a spark but the burner is not igniting
The spark plug and the part
of the burner where the
spark should be is soiled or
greasy
Clean the end of the
spark plug and the
burner
Do not light the gas burners
Gas is not coming through
to the hob
Check that the gas
cylinder tap is properly
open
If it is piped gas, open
the gas tap
The burner ignites but, when you stop holding down the
knob that activates the safety feature, it goes out again
The flame is not appearing
in the area heated by the
thermocouple
Clean the burner’s
openings
The pan is sticking to the glass
Something has melted bet-
ween the pan and the glass.
Pans with aggressive bases.
Set the hotplate to full
power and try to unstick it.
Check the bases of your
pans and do not slide
them across the glass.