Asus DSL-N12U - Manuale (Pagina 50)

0 DSL-N12U Appendice
FCC/Canada Radiation Exposure Statement
This equipment complies with FCC/Canada radiation exposure limits set forth for
an uncontrolled environment.
This equipment should be installed and operated with minimum 20cm between the
radiator and your body.
IC Warning Statement
This device had been designed to operate with the antennas for a maximum gain
5dBi, antenna type: dipole.
Antennas not described as above are strictly prohibited for use with this device.
This device complies with RSS-210 of the Industry Canada Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
Ce dispositif est conforme à la norme CNR-210 d’Industrie Canada applicable
aux appareils radio exempts de licence. Son fonctionnement est sujet aux
deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage
préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un
brouillage susceptible de provoquer un fonctionnement indésirable.
NOTICES:
• This equipment meets the applicable Industry Canada Terminal Equipment
Technical Specifications. This is confirmed by the registration number. The
abbreviation, IC, before the registration number signifies that registration
was performed based on a Declaration of Conformity indicating that Industry
Canada technical specifications were met. It does not imply that Industry
Canada approved the equipment.
• The Ringer Equivalence Number (REN) for this terminal equipment is 01.
The REN assigned to each terminal equipment provides an indication of
the maximum number of terminals allowed to be connected to a telephone
interface. The termination on an interface may consist of any combination of
devices subject only to the requirement that the sum of the Ringer Equivalence
Numbers of all the devices does not exceed five.
AVIS :
• Le présent matériel est conforme aux spécifications techniques d’Industrie
Canadaapplicables au matériel terminal. Cette conformité est confirmée par le
numérod’enregistrement. Le sigle IC, placé devant le numéro d’enregistrement,
signifie quel’enregistrement s’est effectué conformément à une déclaration de
conformité et indique queles spécifications techniques d’Industrie Canada ont
été respectées. Il n’implique pasqu’Industrie Canada a approuvé le matériel.
• L’indice d’équivalence de la sonnerie (IES) du présent matériel est de 01.
L’IESassigné à chaque dispositif terminal indique le nombre maximal de
terminaux qui peuvent êtreraccordés à une interface téléphonique. La
terminaison d’une interface peut consister en unecombinaison quelconque