VDO Z1 User Manual

Page 27

Advertising
background image

18

EN

different weather conditions at the various points of the trip. You should
make corrections so that the measurement is as accurate as possible.
Tip home altitude:
You can obtain the correct information for the altitude of your home lo-
cation or your usual trip starting point from your local weather bureau.

Tip actual altitude:
When planning trips you can find the original altitudes at certain points
of your trip on special maps. These maps are available in book stores.

8.1. SETTING THE HOME ALTITUDE (STARTING ALTITUDE)
3 sec.

ç

Setting mode LANGUAGE SELECT

∂ ƒ

HOME ALTI SET

∂ ƒ

Setting the home altitude

HOME ALTI ?SET OK?

HOME

ALTI

SET

DONE

Automatic return to the operation mode for ALTI UP. The set home
altitude will be displayed as actual altitude. Home altitude set done

Re-calibrating the air pressure to home altitude. Important: Prior to
each trip the actual measured pressure must be calculated back to the
set home altitude = re-calibrate. Short-cut press the ¥ button for 4
seconds.

8.2. SETTING THE ACTUAL ALTITUDE
3 sec.

ç

Setting mode LANGUAGE SELECT

∂ ƒ

ACTUAL ALTI SET

∂ ƒ

Setting the actual altitude

ACTUAL ALTI ?SET OK?

ACTUAL

ALTI

SET

DONE

Automatic return to the operation mode for ALTI UP. Actual altitude set
done

8.3. ANNUAL UPHILL ALTITUDE GAIN BIKE 1 AND BIKE 2 AND WALK
MODE
Your VDO computer accumulates values for the meters in altitude for
the uphill gain covered separately for:
- Bike 1
- Bike 2
- Walk mode (see chapter 10 for selection)
These values can be programmed in, if for example you want to trans-
fer the values from an older device, or if the values have been deleted
when changing batteries.
Setting the annual uphill gain in altitude
3 sec.

ç

Setting mode LANGUAGE SELECT

∂ ƒ

ALTI UP SET

ALTI UP 1 SET (for bike 2 or walking

ƒ

ALTI UP 2 SET / WALK UP SET)

ALTI UP 1 NEXT DIGIT/ ALTI UP 2 NEXT DIGIT / WALK
UP NEXT DIGIT

∂ ƒ

Set last digit (keep button depressed for fast
run-through)

... repeat for all digits from back to front

ALTI UP 1 ?SET OK? / ALTI UP 2 ?SET OK?
/ WALK UP ?SET OK?

HOME AL

TITUDE

Advertising