Yamaha RX-V620RDS - Manuale (Pagina 32)

30
TUNING
Connecting the Antennas
Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal
strength.
Connect each antenna correctly to the designated terminals.
Indoor FM
antenna
(included) AM loop
antenna
(included)
Ground (GND terminal)
For maximum safety and
minimum interference, connect
the antenna GND terminal to a
good earth ground. A good earth
ground is a metal stake driven
into moist earth.
■ Connecting the indoor FM
antenna
Connect the included indoor FM antenna to the FM ANT
75
Ω UNBAL. terminal.
Note
• Do not connect an outdoor FM antenna and the indoor FM
antenna at the same time.
■ Connecting the AM loop antenna
1 Press and hold the tab to unlock the terminal
hole.
2 Insert the AM loop antenna lead wires into
the AM ANT and GND terminals.
AM ANT GND FM ANT
75 UNBAL.
TUNER
5
4
Antenna stand
3 Release the tab to lock the lead wires.
Lightly pull the lead wires to confirm a good
connection.
4 Attach the loop antenna to the antenna
stand.
5 Orient the AM loop antenna so that the best
reception is obtained.
y
• The AM loop antenna can be removed from the stand and
attached to a wall, etc.
Notes
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer
reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the
quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.
Connecting a coaxial cable to the included
75-ohm/300-ohm antenna adapter (U.K. model
only)
11 (7/16)
8 (5/16)
6 (1/14)
1 2
3
5 4
Cover
Unit: mm
(inch)
Lead wire
Clamp with
pliers. Clamp
with
pliers.
Insert the wire
into the slot.
Open the cover of the
included 75-ohm/300-ohm
antenna adapter. Cut the external sleeve of
the 75-ohm coaxial cable
and prepare it for
connection.
Cut the lead wire and
remove it.
Insert the cable wire into the
slot, and clamp it with
pliers.
Snap the cover into
place.
1
2
3
0106V620RDS_30-34_EN 1/18/1, 7:25 PM 30