Yamaha RX-V395RDS - Manuale (Pagina 8)

8
FM
ANT
AM
ANT
GND
75 Ω UNBAL.
GND
MONITOR
OUT
DVD/LD TV/DBS
IN OUT
VCR
IN OUT
VCR
PHONO CD DVD/LD TV/DBS
1 3 4
A OR B: 4 Ω MIN. /SPEAKER
A B: 8 Ω MIN. /SPEAKER
: 6 Ω MIN. /SPEAKER
: 6 Ω MIN. /SPEAKER
A OR B: 8 Ω MIN. /SPEAKER
A B:16 Ω MIN. /SPEAKER
: 8 Ω MIN. /SPEAKER
: 8 Ω MIN. /SPEAKER
MAIN
R
L
SURROUND
R
L
CENTER
SUB
WOOFER
6CH DISCRETE INPUT
VIDEO SIGNAL
TAPE/MD
AUDIO SIGNAL
AC OUTLETS
MAIN
CENTER
REAR
MAIN
CENTER
REAR
I00W MAX. TOTAL
SWITCHED
IN OUT
(REC) (PLAY)
R REAR
(SURROUND)
FREQUENCY
STEP
100kHz
/10kHz
FM / AM
SET BEFORE POWER ON
IMPEDANCE SELECTOR
A
B
VOLTAGE SELECTOR
50kHz
/ 9kHz
GND
OUTPUT AUDIO IN VIDEO IN
AUDIO OUT VIDEO OUT
VIDEO IN
AUDIO OUT VIDEO OUT
LINE OUT LINE IN OUTPUT VIDEO OUT AUDIO OUT
MAIN
LEVEL
-10dB 0dB
CONNECTIONS
CONNECTIONS WITH OTHER COMPONENTS
Never plug in this unit and other components until all connections are completed.
When making connections between this unit and other components, be sure all connections are made correctly; that is to say L (left)
to L, R (right) to R, “+” to “+” and “–” to “–”. Also, refer to the owner’s manual for each component to be connected to this unit.
* If you have YAMAHA components numbered as
1 , 3 , 4 , etc. on the rear panel, connections can be made easily by connecting
the output (or input) terminals of each component to the same-numbered terminals on this unit.
Turntable Monitor TV TV/Satellite tuner Video cassette recorder
<General model>
To AC outlet
LD player,
DVD player, etc. Tape deck,
MD recorder, etc. CD player
*4 AC OUTLETS (SWITCHED)
<Europe, Canada, U.S.A., China and General models>
..................................................... 2 SWITCHED OUTLETS
<U.K. and Australia models> .......... 1 SWITCHED OUTLET
Use these to connect the power cords from your
components to this unit.
The power to the SWITCHED AC OUTLETS is controlled
by this unit’s STANDBY/ON switch or the provided remote
control transmitter’s POWER /I key. These outlets will
supply power to any component whenever this unit is
turned on.
The maximum power (total power consumption of
components) that can be connected to the SWITCHED AC
OUTLETS is 100 watts.
*1
*2
*3
*4
RX-V395RDS
only
*1 Ground (GND) terminal (For turntable use)
Connecting the ground wire of the turntable to the GND
terminal will normally minimize hum, but in some cases
better results may be obtained with the ground wire
disconnected.
*2 Voltage Selector <China and General models only>
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC power supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
*3 MAIN LEVEL Switch RX-V395RDS only
Normally set to “0 dB”. If desired, you can decrease the
output level of the MAIN SPEAKERS terminals by 10 dB by
setting this switch to “–10 dB”.