Yamaha 485RDS - Manuale (Pagina 12)

12
FM/AM
AM FM
1
Select the reception band (FM or AM) while watching
the display.
2
3
Tune to a desired station manually.
* To continue tuning search, press and hold the button.
1
Select the reception band (FM or AM) while watching
the display.
2
3
To tune to a higher frequency, press the right side once.
To tune to a lower frequency, press the left side once.
* If the station where tuning search stopped is not the
desired one, press again.
* If the tuning search does not stop at the desired station
(because the signals of the station are weak), change to
the MANUAL TUNING method.
TUNING OPERATIONS
Normally, if station signals are strong and there is no interference, quick automatic-search tuning (AUTOMATIC TUNING) is
possible. However, if signals of the station you want to select are weak, you must tune to it manually (MANUAL TUNING).
Display information ➀
Displays the band and frequency of the received station.
RX-485 RDS and RX-385 RDS only
If an RDS station is received, the frequency is then
replaced by the station name. (However, if the PS data
cannot be received within 5 seconds, “NO PS” flashes,
and then it returns to the frequency display.)
Refer to page 17 for details.
➁
Illuminates when an FM stereo broadcast is received in
stereo.
➂ Indicates the signal level of the received station.
Note
If you tune to an FM station manually, it is received in
monaural mode automatically to increase the signal quality.
AUTOMATIC TUNING MANUAL TUNING
2
3
1
FM/AM
TUNING
MODE
AUTO/MAN’L MONO
TUNING
MODE
AUTO/MAN’L MONO
TUNING DOWN UP
TUNING DOWN UP
STEREO
0 MHz 40 60 20 l00 FM
➀ ➁
➂
➀ ➁
➂ STEREO
0 MHz 20 l00 FM
AUTO TUNING
“AUTO TUNING”
goes off.
or AM FM
or
RX-385
RX-485 RDS, RX-385 RDS