Lincoln Electric INVERTEC V350-PRO - Manual (Page 18)

B-6 OPERATION B-6
WELD MODE DETAILS:
INVERTEC® V350-PRO
Mode Range Comments
Stick Soft 5 - 425 amps The stick soft mode is the best selection for general stick
applications.
Arc Control = Arc Force
Hot Start = Initial hot start current (min = start a match set amps, Max. =
greatest hot start current) During hot start, arc force is set at
high and is fast response.
For gouging applications: Turn current up to 425 amps.
Stick Crisp 5 - 425 amps The stick crisp mode features an aggressive arc force routine well suit-
ed for Exx10, Exx11 series electrodes.
Arc Control = Arc Force
Hot Start = Initial hot start current (Mid range = welding current and will
vary up and down with knob control.) During hot start, arc
force is set at high and is fast response.
For gouging applications: Turn current up to 425 amps.
GTAW (Tig mode) 5 - 425 amps The tig mode produces a soft, steady constant current waveform for
either touch start or high frequency assisted start DC GTAW applica-
tions.
Hot Start = Min to Mid range = Touch start with low OCV
Mid to Max range = High frequency assisted starting with adjustable
OCV up to 70 volts.
GMAW - CV 10 - 45 volts The GMAW - CV mode is the best selection for general MIG welding,
Metal core, and gas shielded applications.
Arc Control = Pinch (Min = min pinch, softest arc),
(Max = max pinch, crispest arc)
FCAW-SS 10 - 45 volts The FCAW-SS mode is designed for Self Shielded Innershield products
that require tight voltage control. For example; the NR 203 series or NR
207)
Arc Control = Pinch (Min = min pinch, softest arc),
(Max = max pinch, crispest arc, )
ADVANCED PULSE PANEL WELDING PROGRAMS
Gouging 60 - 425 amps The gouging mode is a low power version of other Lincoln welding
equipment gouging programs, for example a Power Wave 455.
GMAW - Power 1 - 18 (No Units) The GMAW - Power mode features good stable short arc performance
when welding small diameter (.025 and .030 steel & stainless) wires at
low procedures. This mode also performs well welding aluminum in the
spray mode.
This mode does not allow preset voltage. In the short arc GMAW mode,
the set KW will not equal the actual Volts * Amps. The set power is reg-
ulated only when an arc is present. During shorting, the output is
allowed to increase to clear the short.