Panasonic EY6932 - Manuale (Pagina 5)

2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the battery
pack out of №e tool body.
m. OPERATION
Switch Operation
1. The speed increases with the
amount of depression of the trigger.
When beginning work, depress the
trigger slightly to start the rotation
slowly.
2. A feedback electronic controller is
used to give a strong torque even in
tow speed.
3. The brake operates when the trig­
ger is released and the motor stoj^
immediately.
Note:
When the brake operates, a brak­
ing sound may be heard. This is
normal.
Forward/Reverse lever Operation
(Fonward (O). Switch lock. Reverse (p))
CAUTION:
Do not operate Forward/Reverse
tever unta the chuck conres I d
a com­
plete stop. Shifting during rotation of
ttie chuck may damage ftie tool.
Forward Relation Switch Operation
1. For forward rotation, set the lever to
fonward.
2. Depress the trigger switch slightly to
start the tool slo^.
3. The speed increases with the
amount of depression of the trigger
for eflicient tightening of screws and
drilling. The brake operates and the
chuck stops immediately when the
trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch Operation
1. For reverse rotation, set the lever to
reverse. Check the direction of rota­
tion before use.
2. Depress the trigger switch slightly to
start the tool sloi^.
3. After use, set the lever to its center
position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 5 pos­
sible settings or * 0 “, T“ position to
the job.
CAUTION:
Test the setting before actual opera­
tion.
Set the scale at this line.
Reference for Adjusting Torque
fSttU
Torque Use
1
Approx. 1.0 Nm
(10kgkmorB.7kvl)s.)
For driving
terminal screws
Fior driving
machine screws
For driving screws
Mosoftmalerials
2
Approx. iSNin
(15kgkmor13.0in-l)S.)
3
Approx. 2.5 Nm
(25l(gkmor21.7in4)s.)
4
Approx. 3.4Nm
(is kgkm or30.47 k)4)S.)
For driving screws
htohardvi^
5
Approx. 4.4 Nm
(45 kgfem or 39.0 in-lbs.)
EY6903:
17.8 Nm(182l(^ 158
M&)(|xwspeed)
EY6932:
255Nm(280l(gfcm,22S
M&)(Lowspeed)
Forpowery
driving and driMng
T
Percussion
For drilling to
tnortar, brick, etc.
-5-