Dell 4350 Network Access Point Manuale d'uso

Pagina 63

Advertising
background image

preliminary authorization procedure by the Ministry of Defence, with maximum authorized power of 100 mW in the 2446.5 - 2483.5
MHz band. Use outdoors on public property is not permitted.

In the departments listed below, for the entire 2.4 GHz band:

Maximum authorized power indoors is 100 mW

Maximum authorized power outdoors is 10 mW

Departements in which the use of the 2400 - 2483.5 MHz band is permitted with an EIRP of less than 100 mW indoors and less
than 10 mW outdoors:

01

Ain Orientales

36

Indre

66 Pyrénées

02

Aisne

37

Indre et Loire

67 Bas Rhin

03

Allier

41

Loir et Cher

68 Haut Rhin

05

Hautes Alpes

42

Loire

70 Haute Saône

08

Ardennes

45

Loiret

71 Saône et Loire

09

Ariège

50

Manche

75 Paris

11

Aude

55

Meuse

82 Tarn et Garonne

12

Aveyron

58

Nièvre

84 Vaucluse

16

Charente

59

Nord

88 Vosges

24

Dordogne

60

Oise

89 Yonne

25

Doubs

61

Orne

90 Territoire de Belfort

26

Drôme

63

Puy du Dôme

94 Val de Marne

32

Gers

64

Pyrénées Atlantique

This requirement is likely to change over time, allowing you to use your wireless LAN card in more areas within France. Please
check with ART for the latest information (

www.art-telecom.fr

)

NOTE:Your Dell Wireless 4350 Small Network Access Point transmits less than 100 mW, but more than 10 mW.

Back to Top

Italia

A license is required for indoor use. Outdoor use is prohibited.
E' necessaria la concessione ministeriale anche per l'uso interno. Verificare con i rivenditori la procedura da seguire. L'uso per
installazione in esterni non e' permessa.

Back to Top

USA -- Federal Communications Commission (FCC)

This device complies with Part 15 of the FCC Rules. Operation of the device is subject to the following two conditions:

This device may not cause harmful interference.

This device must accept any interference that may cause undesired operation.

Dell declares that WAPA-118GD ( FCC ID: MXF-A930909G ) is limited in CH1~CH11 for 2.4GHz by specified firmware controlled
in U.S.A.

Interference statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed and used in accordance with
the instructions, the equipment may cause harmful interference to radio communications. There is no guarantee, however, that such
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception (which can be determined by turning the equipment off and on), the user is encouraged to try to correct the interference
by taking one or more of the following measures:

Advertising