Rockford Fosgate PCH-14X User Manual

Page 10

Advertising
background image

5. Place the mounting ring over the hole.
6. Attach the wires and be sure to observe the proper speaker

polarity. Keep the speaker wires away from sharp and
moving objects.

7. Place the speaker into the hole and screw the speaker into place.

Be careful not to bend the speaker frame during this step.

8. Press the speaker grille into the mounting ring.

Flush Mounting the Tweeter

– 7 –

1. Cut a 1-1/4" mounting hole.
2. Route the wires through the mounting hole.
3. Attach the wires and be sure to observe the proper speaker polarity.

Keep the speaker wires away from sharp and moving objects.

4. Snap the tweeter with the flush mount capsule into the hole.
5. Angle the tweeter for best sonic performance.

Surface Mounting the Tweeter

Mounting
Plate

1. Place the mounting plate on the surface where the tweeter will be

located. Mark two (2) opposing mounting holes and the center wire
access hole.

2. Remove the mounting plate and drill a 1/4" (6.4mm) hole for the

speaker wire access. Drill two (2) 1/8" (3mm) holes for the
mounting screws.,

3. Route the wires through the mounting hole.
4. Place the mounting plate in position by threading the speaker wires

through the center hole. Mount the mounting plate with the
provided mounting hardware.

5. Attach the wires and be sure to observe the proper speaker polarity.

Keep the speaker wires away from sharp and moving objects.

6. Snap the tweeter onto the mounting plate.

I

N
S
T
A
L
L
A
T

I

O
N

®

®

Advertising
This manual is related to the following products: